If not then repeat the previous steps.
How many turns on awning spring.
See our channel page for link the home on the road series consists of three 2 dvd.
New dometic heavy duty springs installed on a 19 8500 awning set at 8 turns do not retract the awning without me pushing it up.
Generally it will take six turns for awning lengths of 8 to 12 feet seven turns for 13 to 14 feet eight turns for 15 to 16 feet 10 turns for 17 to 18 feet 11 turns for 19 to 21 feet and 12 turns for 22 to 25 feet.
Roger it depends on the age of the torsion assemblies and if you add the windings while the awning is in the travel position or the extended position.
Adjust awning tension adjust spring tension rv awning how to adjust the tension on an rv awning awning tighting adjustments how to adjust spring tension on rv awning rv awning tension loose adjust rv awning spring rv awning spring tension.
The unwinding can also be done while standing on the ground and the awning fully extended and the opposite side rafter locked in place.
The torsion spring will be wound with 8 eight more turns in this position and is extremely dangerous.
How tight can i safely read more.
Roll the awning back up to observe how tight it is.
Reinsert the end cap into the awning arm and install the bolt.
Remember you are adding the initial turns to the turns that the awning gets as it unrolls.
You do not need to put the screws back in.
This however will still depend on the model of the rv awning that you own.
It s best to check your rv awning manual to determine the number of turns you ll need winding up your spring.
If you are satisfied move on.
Repeat the process with the rear support arm but rotate it clockwise rather than counterclockwise one turn.
Unfortunately you can t be certain at this point that you ve tightened the awning sufficiently.
Only rotate the legs one or two turns at a time and don t do more than 4 or 5 total.
Rotate the support arm at the front end of the awning counterclockwise one complete turn.
Turn the spring top away from the coach.
Severe injuries can result from the rapid spin off of the top casting.
Rotate the support bar one turn to tighten the spring.
Attach the vice grips to the new ratchet assembly and rotate as many turns as noted in step 6.
Here s the recommended number of turns but keep in mind the older the assembly the more likely you ll have to add one or two more.