Allow approximately 1 32 0 8mm clearance the thickness of a dime between the fastener head and the vinyl.
How tight to nail vinyl siding.
Prodigy one piece insulated siding system.
To install vinyl siding to the soffit and fascia area on your home nail lengths of j channel along the inner edge of the fascia leaving the nail heads out about 1 32 to 1 16 of an inch.
Simply go outside grab the lower edges of a siding course and try to slide it back and forth photo 1.
Vinyl siding tends to expand and contract considerably with temperature changes.
The problem should be easy to diagnose.
Do not nail to the extreme right or left of nail slot in siding panel.
Do not drive the head of the fastener tightly against the siding nail hem.
Following is a discussion of how to do both.
Vinyl siding can either be nailed by hand with a hammer or by a power nailer.
Center nails in slots.
Tight nailing screwing or stapling will cause the vinyl siding to buckle with changes in temperature fig.
This will permit expansion and contraction as well as prevent dimpling which causes waves in siding.
Drive nails straight and level.
Integrated 1 thick eps rigid foam insulation nominal helps reduce utility costs and reinforces the siding.
Vinyl siding that s nailed on too tight doesn t leave room for the materials to expand and contract and that causes ripples to form come summertime.
Secure interlocking panel design provides a tight fit with no insulation gaps.
Next measure and cut the siding to fit the measurements of your soffit and push each panel into the j channel.
For the best results leave at least 1 16 inch between the nail head and the siding to give it some room to grow.
Fully rolled over nail hem securely anchors panels to the wall.
An expert guide on the best way to nail vinyl siding either by hand or using a power nailer.
Learn more on proper nailing for vinyl siding installation how to install vinyl siding.
Also learn the right way to hang siding with insulation in mind.
Do not drive nails tight.