How To Attach A Ledger Board To Wood Siding

Make sure you have enough room to install flashing above the ledger board and allow for at least a space above the decking preventing water from wicking upwards into wood siding.

How to attach a ledger board to wood siding.

Get 4 inches of the flashing under the bottom of the siding. These 18 articles will teach you how to install flashing and bolt the ledger connection to the house rim. Learn the tools techniques materials and fasteners to properly install a deck ledger board arguably a deck s single most important connec. Step 1 determine the size of the ledger board to ensure proper strength a ledger board should be made out of the same size lumber that was used to make the deck joists usually 2 inch by 10 inch boards.

A ledger relies on the fasteners and strength of the wood ledger board and rim board of the house to carry the deck live and dead loads. Step 5 attach ledger board. Most house framing relies on building elements floors walls roofs being stacked one atop another. Start by making an outline on the siding where you want to position the ledger board.

Start by using plunge cuts across the top and bottom of the horizontal length of the ledger board followed by the shorter vertical cuts for the ends using a. Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides. Fasten the ledger board with 1 2 inch bolts and washers. Secure flashing with galvanized nails.

Then cut away the siding. Slip the flashing under the siding so it will cover the ledger board. Nail undersill trim j channel will also work over the bottom cut using 11 gauge aluminum nails. Fastening to masonry walls.

Drill 1 2 inch holes through the ledger board into the planks between joists. Properly installing a ledger board for your deck is one of the most important structural components of building a safe and strong deck. Drill holes for the expanding anchors every 16 inches or as specified by local codes insert the anchors hold the ledger in place and tap it with a hammer to indent the anchor locations on its back face.